[TheForge] hydraulics

[Cameron Stoker]

You might look at surplus center - this one is too small, but they may =20=

have a larger 50/50 divider valve. I'm not sure if this is what you are =20=

talking about, nor do I have experience with these valves, but it's =20
less that $500 ...


http://surpluscenter.com/item.asp?UID=3D2003041522595846&item=3D9-1048-=20=

A&catname=3Dhydraulic

On Tuesday, April 15, 2003, at 08:24 PM, Ed F wrote:

> Hi Chuck,
>
> I just checked into a rotary flow splitter - guy at the hydraulic shop =
=20
> says
> they will start at about $500.  Wheew, I think I'll look at doing it =20=

> with
> one again.  The inverted style or whatever you call it with the =20
> cylinder
> below the work-surface pulling on tension bars may work ok for =20
> punching if
> the top of the cylinder is put on blocks to allow for a horizontal =20
> hole to
> push the slug out with.  The blocks would eat up clearance to the =20
> floor but
> I was thinking of spacing the low cross-member pieces out so that they =
=20
> can
> clear the outside of the barrel.  Ya know what I'm sayin?
>
> Ed
>
>
>
				Cameron Stoker
				cameron@stoker.net
				"May you run like a vicu=F1a!"
				pgp key @ http://keys.stoker.net