[TheForge] was Air Hammer Slides.....

Thu Apr 10 00:06:00 2003

For 95.00 I sell the Hub, Spindle, Bearings, and Dual Mounting plates, for a
swing arm crane.

Weight ratings depend on how you design / counter balance you crane, and how
good you trust your welds.

All you need is a Floor plate 1/2" thick minimum 2' x 2' with 8 bolt holes,
for a minimum 5/8 Bolt.
8"x8" spare 1/2" thick top plate to mount the spindle on to.

20' of 8" I-beam x 18.4#  or an equivalent 8x8 x .25 box tube, or 8" round
pipe.  new I-beam will be cheaper than either Box or Pipe.

14.5' of 6" I beam 12.3# for the swing arm.  There are other mods, and misc
parts you can add at your choice

Here are two pictures of one that was recently built and installed in my
shop.
http://www.bograt.com/misc%20graphics/shop%20crane/

Any questions email me

[email protected]

----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Wednesday, April 09, 2003 8:36 PM
Subject: Re: [TheForge] was Air Hammer Slides.....

> I am interested in building a swing arm crane, any information would be
> appriciated, thanks, Ralph
>
> Ralph Neumeister
> Maple Leaf Forge
> 17231 Messenger Rd.
> Burton, Ohio 44021
>
>
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment.  Attachments are not allowed.  To learn how
> to post in Plain-Text go to: http://www.expita.com/nomime.html  ---
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>