[TheForge] Re:Sal Ammoniac for flux

Wed Sep 18 23:24:01 2002

Brian, I don't know where to get it, but I do know that it is also used for
cleaning & curing soldering coppers.
dave m

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Brian Gilbert
Sent: Wednesday, September 18, 2002 7:31 PM
To: [email protected]
Subject: [TheForge] Re:Sal Ammoniac for flux

OK, folks, here's a puzzler...

Does anyone know of a cheap source of or common use for sal ammoniac
(ammonium chloride)? I want to use some to blend up my own flux, but
everything that I've found so far is more expensive than commercial welding
flux.

The only common use that I've found so far is for stained glass workers. I'm
sure it's probably some sort of cleaning powder, but I'm not sure.

any ideas?

Thanks
BG

--
Brian Gilbert
Editor, The Hammer's Blow

_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________