[TheForge] Cnc Plasma cutting table

Tue Nov 19 06:47:01 2002

        Shannell, You've sparked an interest in seeing this unit you've
made, any chance you could post a picture or send me one of this unit?  How
large a sheet does it take? a 48" x 48" or full sheet? or smaller sections?

Ralph


----- Original Message -----
From: "Shannell Sugrue" <[email protected]>
To: <[email protected]>
Sent: Tuesday, November 19, 2002 1:53 PM
Subject: Re: [TheForge] Cnc Plasma cutting table


> Build your own, they will sell you the electronics at inflated prices
(IMO),
> you can buy 3 axis drivers for 1-300 bucks US and the rest is simple
> engineering, copy their designs for the table they are basic and work
well,
> get a torch without high frequency start, you dont even need a machine
> torch, you can usually retro fit machine switching of the torch to the
> machine easily. I built mine for about $700 USD excluding plasma of
course,
> if the electrics scare you its just basic wiring up of the different
> components. There are a lot of web resources out there for cnc.
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>