[TheForge] Mastermyr

[Larry and Pat Brown]

I did the spoon augers, when the measurements didn't make sense I used the 
overall measurement to scale the rest of it.
Larry Brown

At 06:06 PM 5/28/2002 -0700, you wrote:
>To be honest I am not sure as to the strip that is referred to. The text 
>is from the book. But it could be the center strip. Perhaps. If the center 
>strip were two separate pieces as they look like that were riveted together.
>But I am not sure.
>
>Ralph
>
>At 10:59 AM 5/28/02 -0400, you wrote:
>>Ralph,
>>
>>Follow all your dimensions but the "strip width 0.45 cm, thickness 0.25 
>>cm"   What's this referring to?  If its the center strip the dimensions 
>>don't seem right.   From the pictures and sketches the center strip 
>>between the grid rods appears wider and thinner than the grid rods. Am 
>>planning on making these 2 strips 3/4" by 1/8" (That would be 1.9 cm by .3 cm)
>>
>>Ralph wrote:
>>
>>>I hope this helps.
>>>
>>>Frame about 50 X 50 cm: strip width 0.45 cm, thickness 0.25 cm; grid 
>>>rods 49.0 X 1.2 X 0.3-0.5 cm.
>>>Chain links about 0.6-0.7 cm, total length of each chain about 42 cm. 
>>>Swivel: four-armed plate
>>>about 16 X 9 cm, thickness 0.3 cm; hook 10.3 X 1.5 X 0.7 cm; the open 
>>>part of the hook maximum
>>>width 1.5 cm.
>>
>>"Good is the enemy of Excellent. Talent is not necessary for Excellence.
>>Persistence is necessary for Excellence. And Persistence is a Decision."
>
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith@hotmail.com
>password:  anvil
>___________
>