[TheForge] hammer controls

Sun Jul 28 17:21:00 2002

I was asked about the controls on the Bull, was it metered on the in side of
the circuit or on exhaust.
----- Original Message -----
From: "Andrew Vida" <[email protected]>
To: <[email protected]>
Sent: Sunday, July 28, 2002 11:43 AM
Subject: RE: [TheForge] hammer controls

What sort of difference are you asking about Bob?  The only difference I
know of is
in the load balanced valving that Mike LInn concocted where you place a
regulator on
the full face side of the cylinder to match the effective pressure with the
end that
carries the piston rod.

-----Original Message-----
From: Bob Bergman [mailto:[email protected]]
Sent: Sunday, July 28, 2002 9:16 AM
To: [email protected]
Subject: [TheForge] hammer controls

Is there a difference on metering air in or air out with a Kinyon style
hammer?Bob

_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________

_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________