[TheForge] Cheap clear finish question

Sun Jan 13 19:04:08 2002

i've never used it but have heard that watco (used by a lot of woodworkers) makes a decent finish for metal. has anyone tried watco or have any comments.

bob s.
______________

>In a message dated 1/12/02 9:10:15 PM, [email protected] writes:
>
><< > Hey,
>>
>> My daughter is refinishing a couple of metal chairs and table and I've
>> helped her wire brush the old paint off and convinced her that the beauty of
>> the bare steel is much greater than that of paint and want to help her spray
>> paint a clear finish on them.  Short of going the powder coat route I'm
>> wondering what the best cheap easy (get my drift?) route is?  I'm torn
>> between lacquer from a spray can or polyurethane from a spray can.  The
>> chairs and table are for inside use.  Opinions?
>>
>> Thanks,   Jeff Valentine >>
>
>Use FUTURE FLOOR POLISH.
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  [email protected]
>password:  anvil
>___________