[TheForge] gas burner design

Wed Jan 2 09:53:01 2002

Hello Ralph
           im not sure what you plans are but . you have more temp control with a blower type forge , and easy operate - no burner burn out -- no flare needed-- no changing
orifices;  if powering the blower device is a problem you could run it off of the battery from the  T Model
    Just run a cable to the battery if you are power deprived  GRIN
                  Bowie  Happy New Year

> The burner that Ron Riel mentions (simple burner design), I think that is what it is called, should work fine. You may have to choke the air intake, duct tape works for testing.
>
> Regards Daryl
>
> "Ralph Sproul" <[email protected]> wrote:
>
> >        Anyone have any good burner designs they have made that can be
> >pointed at the material being heated at 3-4" away from the stock? and not
> >have it scale to badly?  This is the question I should have asked in
> >conjunction with the tapered stainless question I sent in.
> >
> >Ralph Sproul - Bear Hill Blacksmith
> >Webster, NH
> >
> >_______________________________________________
> >http://mailman.qth.net/mailman/listinfo/theforge
> >theforge mail list group photo site is
> >http://albums.photopoint.com/j/AlbumList?u=1169182
> >___________
> >
> >
> >
> --
>
> __________________________________________________________________
> Your favorite stores, helpful shopping tools and great gift ideas. Experience the convenience of buying online with Shop@Netscape! http://shopnow.netscape.com/
>
> Get your own FREE, personal Netscape Mail account today at http://webmail.netscape.com/
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________