[TheForge] Re: Air hammer valves

Sat Dec 14 13:03:00 2002

When you do get a chance to look, I think you will find that one of the reed
valves passes air to hold the TUP up when the main valve is in the idle
position and the other reed valve lets in air from outside as needed.

Darrell

----- Original Message -----
From: "Mike Spencer" <[email protected]>
To: <[email protected]>
Sent: Friday, December 13, 2002 11:04 PM
Subject: [TheForge] Re: Air hammer valves

>
>
> darrell> Ok, looking at the picture again I can see the other clamp.
>
> Just barely, through the rectangular port, right?  Right.
>
> > Now the question is where do the ports that mate with the round side
> > of the valve go?
>
> Right.  Stay tuned, as they say, to this channel.  If I:
>
>   + had nothing else to do
>
>   + didn't have to set up staging to get at the top of the A&O
>
>   + didn't have to take the staging down to replace the tarp
>
>   + and could count on a week of nice weather
>
> I'd be working on this but as it is, it'll be at least March, probably
> April, before I get back to working on the hammer.
>
> Gotta get the 25# LG going, do some more wiring, rig up somthing for a
> little heat in the shop, do some overdue car/truck/trailer repairs and
> maybe even -- sigh -- do some actual hot iron bashing in the new shop.
>
> - Mike
>
> --
> Michael Spencer                  Nova Scotia, Canada
>
> [email protected]
> http://home.tallships.ca/mspencer/
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>