[TheForge] Re: Air hammer valves

[Mike Spencer]

darrell> Ok, looking at the picture again I can see the other clamp. 

Just barely, through the rectangular port, right?  Right.

> Now the question is where do the ports that mate with the round side
> of the valve go?

Right.  Stay tuned, as they say, to this channel.  If I:

  + had nothing else to do

  + didn't have to set up staging to get at the top of the A&O

  + didn't have to take the staging down to replace the tarp

  + and could count on a week of nice weather

I'd be working on this but as it is, it'll be at least March, probably
April, before I get back to working on the hammer.

Gotta get the 25# LG going, do some more wiring, rig up somthing for a
little heat in the shop, do some overdue car/truck/trailer repairs and
maybe even -- sigh -- do some actual hot iron bashing in the new shop.

- Mike

-- 
Michael Spencer                  Nova Scotia, Canada 
                                 
mspencer@tallships.ca            
http://home.tallships.ca/mspencer/