[TheForge] Burner flare taper

Thu Apr 25 20:18:00 2002

Dam, now Im gonna chuck my ez burners and make some minimongos, you shouldnt
have shown me that page today, I saw it a while back but I was quite happy
till now.

----- Original Message -----
From: "Larry" <[email protected]>
To: <[email protected]>
Sent: Friday, April 26, 2002 1:14 AM
Subject: Re: [TheForge] Burner flare taper

> duh, I failed to post the link.  Sorry.
>
> Check out this page, http://www.hybridburners.com/    if it
> does not answer your question, he may be willing to answer
> it for you.  Please post your find, I too am interested.
>
> Larry
>
> Shannell wrote:
>
> > Im machining some burner flares today and was wondering about the taper,
I
> > recall a 1:12 ratio, does that mean the whole flare or the actual angle
of
> > taper ie- do I setup the lathe for 4.8 degrees which is 1:12 or at 2.4
> > degrees which is 1:24 but both sides machined equal out to 1:12?
> >
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
>
>