[TheForge] Burner flare taper

[Larry]

duh, I failed to post the link.  Sorry.

Check out this page, http://www.hybridburners.com/    if it
does not answer your question, he may be willing to answer
it for you.  Please post your find, I too am interested.

Larry

Shannell wrote:

> Im machining some burner flares today and was wondering about the taper, I
> recall a 1:12 ratio, does that mean the whole flare or the actual angle of
> taper ie- do I setup the lathe for 4.8 degrees which is 1:12 or at 2.4
> degrees which is 1:24 but both sides machined equal out to 1:12?
>