[TheForge] Miller Welder

[evelyn hart]

Jeff,

Jackson has a new helmet out that goes from a shade 1 to a 12-13 I think.
you can weld and then grind and don't have to take it off.  I saw an add
for it I think in the AWS mag.  I don't remember all the details and can't
find the article.  I don't know about the price.  You can check it out at
their web site.

Bobby Hart
Hush Puppy Forge
Griffin, GA
OBG, AFC 

At 08:13 AM 4/4/02 -0500, you wrote:
>I just bought a new Miller 185, (won't pick it up until I finish the
>drywall), the speed/heat range guide list settings for stainless up to
>3/8".  The heaviest stainless I plan on using is 1/8", so that should
>do me.  Miller has replaced this with it's new  210 model. This one
>was used for 10 minutes, I paid $1180 for it,  how'd I do?
>
>   I'm gonna buy an extra torch for it and have the gas for stainless
>sitting on the side, will take longer to change over than buying a
>spool gun, but I'm not doing production welding.
>
>   Anyone have any experience with the Lincoln auto helmet that goes
>for around $140 and operates on photo cells?   I know a better helmet
>is worth it's price, but again, I'm not doing any production welding,
>just fabrication and repair of my manufacturing equipment.
>
>   Any and all comments and advice always welcome!
>
>   Jeff   ><>
>
>_______________________________________________
>http://mailman.qth.net/mailman/listinfo/theforge
>theforge mail list group photo site is
>http://www.photoaccess.com
>Login:  blacksmithblacksmith@hotmail.com
>password:  anvil
>___________
>
>
>