[Test-Equipment] some test equip for sale....

[Pete Manfre]

I normally only post to TestEquipTrader at yahoogroups dot com but I 
figured I would let people here know about that sire and typical stuff 
posted there.


1- HP 8662a ( opt 003) 100khz  to 1280Mhz Synth sig gen / sweep gen.  
Test and performs as it should.  The freq is withing a few HZ as viewed 
on  my GPS Disp counter.  Output is almost spot on. Has Modulation 
internal also.  Full specs  on line. $650 +  Shipping

2- Fluke 6080A RF Signal Generator features high performance modulation, 
wide output level range, and exceptionally high spectral purity.

The 6080A is ideal for handling critical receiver tests, RF design, and 
ATE systems applications.

Frequency range of 0.1MHz to 1050MHz

Phase noise at 1GHz is: -131 dBc/Hz at 20kHz offset

Non-harmonic spurious performance is -100 dBc at 1GHz

Full modulation capability is standard

AM, FM, pulse, and phase modulation can be combined for complex signal 
simulation.

*Specifications:*

Frequency Range: 10 kHz to 1050 MHz

Frequency Resolution: 1 Hz

Output: -140 dBm to +17dBm

Amplitude Modulation

Frequency Modulation

Phase Modulation

Pulse Modulation

Internal Modulation Source

Waveforms: Sinusoidal, Square, Triangular, Pulse

Triangular, Sine, Square rates: 0.1 Hz to 200 kHz

Pulse rates: 10 Hz to 200 kHz

Frequency Sweep

Amplitude Sweep

Remote Programming Interface: IEEE-488

Have 2 units one good one dented for parts.  Both $700 + Shipping

*3-* *SOLD*   Agilent  53131A counter ....look and test new.  No options 
so they are 225Mhz and time interval.  But have HPIB, RS232, external 
10Mhz in and out, have handle and bumpers.  Have 2 but will sell 1... 
$475 + Shipping.

4- HP 8991A peak power meter with 1- 84812A sensor ( have several 
sensors available ) Tested working. $500 + Shipping

*5-* HP 8711A Scalar Network analyzer , no options, ... Has Version 2.10 
FW   Has been tested. CRT has good brightness and is sharp,  all soft 
keys function properly,  Unit powers up, passes  all self tests, and 
cals fine.  Including a Narda Open / Short / Load with the unit to do 
User cal's.  Basically a nice tested unit in good condition ... but has 
some scratches and sticker residue.  Will send Pic if requested of unit 
running. $525 + Shipping


6- HP 4276A Tested and working.  This was my spare.  I replaced the 
bench one with an 4284a and use  the 4267a from the bench as a spare.  
Included is a 16047a test fixture. $600 + shipping

*7- **HP 8970A *fixer upper / parts unit.  Semi works.  Front panel fine 
and all buttons work as they should.  100% complete.  No desire or time 
to fix this one.   Will let go cheap. $175 + shipping.

8- BR Chirpsounder Receivers 2540 ( also called the RCS-5 HF receiver).  
Has scope and many other featuresI have not powered them up but  look 
clean and serviceable I  have 1 . $300  + Shipping

Thanks for  looking,

Happy Holidays,

Pete WA2ODO


-- 


> ++++++CONFIDENTIALITY NOTICE++++++
> The information in this email may be confidential and/or privileged. This email is intended to be reviewed by only the individual or organization named above. If you are not the intended recipient or an authorized representative of the intended recipient, you are hereby notified that any review, dissemination or copying of this email and its attachments, if any, or the information contained herein is prohibited. If you have received this email in error, please immediately notify the sender by return email and delete this email from your system.



---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus