[Test-Equipment] Source for Fluke 25/27 DMM parts? ADDENDUM

[Barry]

If it's just a loose piece of plastic (Lexan, etc.), then that will work.  I'm not sure, but I think it may be part of an assembly that may not be readily replaced.  I'll know when I get into it.

Thanks!
Barry - N4BUQ


 On Fri 04/05/12  5:37 PM , rbethman rbethman at comcast.net sent:
> Barry,
> 
> Try a Hobby Shop. Perhaps HobbyTown USA. You can by sheets of Lexan 
> smaller than an 8 X 10 size.  Somewhere around 5 x 7 .
> 
> ****************************
> The thickness is about .0045"
> ****************************
> 
> I've used it to make a new window for a Millen GDO, and other projects.
> Cuts with Exacto Knife, or you can get fancy and buy Scissors made for 
> Lexan.  Anyone whom has ever played with R/C Car racing has a pair or 
> two lying around.
> 
> Bob - N0DGN
> 
> On 5/4/2012 5:09 PM, Barry wrote:
> > Anyone know where I can get a new (or used in good
> condition) plastic LCD lens (window) for a Fluke 25/27 DMM?  A pressurized
> can of paint stripper ruptured and spewed paint stripper on my workbench. 
> The DMM's case seems to have survived with minimal damage, but that plastic
> lens didn't fare as well.>
> > I may be able to remove and polish it but if that
> doesn't work, I'd like to try to find a replacement.>
> > Thanks,
> > Barry - N4BUQ
> >
> 
> 
>