[Test-Equipment] HP 8552

Gary Schafer garyschafer at comcast.net
Fri Apr 18 15:43:12 EDT 2008


The jumper is in the terminator plugs that go on the back of the 141T. If I
remember right the jumper has to be in place if you are using the 8553 rf
plug in but is not required for the 8554 plug in.
If you don't have the terminators that go into the jacks you can put a
jumper wire on the proper pins. It is the center conductors of two of the
coaxial connectors in the jacks. Don't short them to ground!

73
Gary  K4FMX

> -----Original Message-----
> From: jeremy-ge [mailto:geoffrey at jeremy.mv.com]
> Sent: Friday, April 18, 2008 3:04 PM
> To: garyschafer at comcast.net; Discussion of Electronic Test Equipment
> Subject: Re: [Test-Equipment] HP 8552
> 
> Where and what is this jumper??
> 
> Geoff
> 
> 
> ----- Original Message -----
> From: "Gary Schafer" <garyschafer at comcast.net>
> To: "'Discussion of Electronic Test Equipment'"
> <test-equipment at mailman.qth.net>
> Sent: Friday, April 18, 2008 2:39 PM
> Subject: RE: [Test-Equipment] HP 8552
> 
> 
> > Be sure that you have the jumper in place on the back of the 141
> > mainframe.
> > The sweep trigger goes thru there depending on what modules are
> installed.
> >
> > 73
> > Gary  K4FMX
> >
> >> -----Original Message-----
> >> From: test-equipment-bounces at mailman.qth.net [mailto:test-equipment-
> >> bounces at mailman.qth.net] On Behalf Of Mark Donaldson
> >> Sent: Friday, April 18, 2008 10:49 AM
> >> To: test-equipment at mailman.qth.net
> >> Subject: [Test-Equipment] HP 8552
> >>
> >> I have 2 HP-8552 spectrum analyzer IF sections that do
> >> not provide an auto sweep output anymore. The manual
> >> scan mode works somewhat, it will move the trace on
> >> the far right side of the 141T display. This problem
> >> is associated with the 8552 not the 141T mainframe
> >> however it is possible that the IF section was damaged
> >> by a 141T mainframe that had power supply issues.
> >> Before I dig into this I was hoping somebody else has
> >> been down this road and knows which part was likely to
> >> have vented its smoke to cause what I am seeing.
> >>
> >>
> >>
> >>
> __________________________________________________________________________
> >> __________
> >> Be a better friend, newshound, and
> >> know-it-all with Yahoo! Mobile.  Try it now.
> >> http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
> >> ______________________________________________________________
> >> Test-Equipment mailing list
> >> Home: http://mailman.qth.net/mailman/listinfo/test-equipment
> >> Help: http://mailman.qth.net/mmfaq.html
> >> Post: mailto:Test-Equipment at mailman.qth.net
> >
> > ______________________________________________________________
> > Test-Equipment mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/test-equipment
> > Help: http://mailman.qth.net/mmfaq.html
> > Post: mailto:Test-Equipment at mailman.qth.net
> >




More information about the Test-Equipment mailing list