[Test-Equipment] Looking for HP PCB fuses

Fri, 14 Feb 2003 00:07:52 -0500

Check Newark Electronics  http://www.newark.com or Allied
www.alliedelec.com.  I got some for an 8620 a while back.

73

Tom

WB3KAD
----- Original Message -----
From: "Carl Walker" <[email protected]>
To: <[email protected]>
Sent: Thursday, February 13, 2003 8:42 PM
Subject: [Test-Equipment] Looking for HP PCB fuses

> Hello. I was wondering if anyone has any of the HP equipment fuses they
used
> on PCBs - specifically, I'm looking for the cylindrical type that's about
> .200" round, perhaps .300" high, with radial leads in a 2 Amp value. These
> are plug-in units that fit into socket pins that are soldered into the
board,
> so they are easily replaced (if you can find them, that is).
>
> This little beast came from the A18 -5.2 volt regulator board in an 8640B.
>
> The markings in the top look something like this;
>
> FM02
> 2A
> LF
>
> Thanks for any help you can provide.
>
> Regards,
>
> Carl Walker, WA1RAJ
> _______________________________________________
> Test-Equipment mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/test-equipment
>