[Test-Equipment] Can Anyone Help?

Wed, 22 May 2002 17:49:41 -0700

The 1021-P2 was the signal generator half of the 1021AU UHF Standard Signal
Generator.  This unit fit into a single cabinet with the 1021-P1 power
supply on the left hand side, and the 1021-P2 on the right.

Perhaps someone on the list has a power supply schematic, or pin-out for the
Jones plug.

Scott
N7NB
----- Original Message -----
From: "Floyd Petri" <[email protected]>
To: "Test Equipment List" <[email protected]>
Sent: Wednesday, May 22, 2002 16:47
Subject: [Test-Equipment] Can Anyone Help?

> I purchased a General Radio U-H-F Unit Type 1021-P2 which was supposed to
be
> a 250-920 MHz Receiver. Upon receiving it I believe it to be a Signal
> Generator. There is no case or cabinet. It has a Jones plug inside which
has
> 8 prongs on it which I think maybe the power connector. On the front panel
> is the tuning dials, an output control dial in Microvolts, a Push to
> Calibrate and an Output connector. I don't know if I can attach a
photograph
> (jpg) to emails on this list. If I can, I can attach a photograph to the
> next email.
>
> Can anyone verify that this is a Signal Generator? Any chance on a
schematic
> and pin out on the plug? Thanks.
>
> Floyd Petri
>
>
> _______________________________________________
> Test-Equipment mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/test-equipment
>