[Test-Equipment] RE: HP 5335A Counter GOT IT!

Sun, 15 Dec 2002 03:03:39 -0500

GOT IT!

Right after I pushed the send button on my first reply to John I read his
answer again and realized he had the answer. I peeled off the calibration
sticker and on the back edge of the cover was a captive screw that slid the
cover off a nice as could be!

Thanks John, I have been puzzling over this for a week, and you got it right
away!

Now is someone has the manual and can supply the part number for option 010,
I will be all set!

Thanks to all for putting up with my question!
Mark  W1MJG

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Mark J. Giubardo
Sent: Sunday, December 15, 2002 2:48 AM
To: [email protected]; [email protected]
Subject: RE: [Test-Equipment] RE: HP 5335A Counter Need Help!

Hi John,

Thanks for your response John.

Yes I have removed the feet. They are large plastic square ones. They do not
screw on, just slide back and then pop off. There are no screws on the
bottom at all! This thing is different from all the rest of my HP gear.
There is probably a series of equipment that come apart the same as this
counter, but I have not had any experience with it. I have removed every
screw that I can find with no luck!

Mark  W1MJG

-----Original Message-----
From: John Miles [mailto:[email protected]]
Sent: Sunday, December 15, 2002 2:14 AM
To: [email protected]; [email protected]
Subject: RE: [Test-Equipment] RE: HP 5335A Counter Need Help!

You've removed the feet from the rear of the counter, right?  Most HP gear
of that era just had the two screws in the feet, plus one in the center rear
(possibly under a calibration sticker).  I'm not familiar with the plastic
strip you removed from the top -- nothing like that should be necessary?

-- jm

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Mark J.
> Giubardo
> Sent: Saturday, December 14, 2002 11:04 PM
> To: [email protected]
> Subject: [Test-Equipment] RE: HP 5335A Counter Need Help!
>
>
> Hi, I am new to this list.
>
> I need to get the top and bottom covers off my HP 5335A counter. I have
> removed the plastic strip on the top and the three screws that
> appear to go
> through the cover, but still can't get it off. I don't want to
> damage it by
> too much force so I am asking for advice from someone that has experience
> with this instrument. I can slide off the side cover that does
> not have the
> handle (left side), but the side with the handle (after removing
> the handle)
> will only slide back about 1 inch and stops.
>
> Also need the HP part number for the Oven Oscillator Option 010.
>
> I have a manual coming via slow boat, but I need to get into the counter
> now.
>
> Thanks to anyone that can help,
>
> Mark   W1MJG
>
>
> _______________________________________________
> Test-Equipment mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/test-equipment
>

_______________________________________________
Test-Equipment mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/test-equipment