[TenTec] Need help with 535/536 address selection

[howard wilson]

Gus, the address appears in the right most digits, e.g. (EC.006.4). I
know of no other way to change the address either by the front control
panel or within the software. I also use the 305 with an ICOM 746. 

73,Howie wa2ncf at juno.com
c

On Fri, 21 Oct 2005 22:38:16 -0600 "Augie (Gus) Hansen"
<augie.hansen at comcast.net> writes:
> On 10/20/05 12:23 PM, "howard wilson" <wa2ncf at juno.com> wrote:
> 
> > Have used the Argonaut 2 with model 305 level converter 
> successfully. My
> > address is set to 64 and is changed by pressing the function and 
> mode
> > keys and then using the up/down keys to modify the address.
> > 
> 
> Thanks for your reply Howie.
> 
> After you activate the address mode, in which positions of the 
> display does
> the code show up? As I noted in my first posting, my display shows 
> EC.000.1,
> and using the up/down buttons changes the rightmost character 
> positions in
> decimal sequence, not hex. I did change it to show EC.006.4 and 
> EC.064.0,
> but no joy with either of these. I'm assuming the two leftmost 
> characters
> are the ones of interest, but it would take a long time to get to 
> them with
> the up/down buttons. And I found no way to do direct code entry with 
> the
> number buttons.
> 
> Perhaps there is a problem with the control circuits for the serial
> interface in the rig. The 305 works fine with my Icom rigs, so I 
> know it's
> good.
> 
> Cheers,
> Gus, KB0YH
> 
> _______________________________________________
> Tentec mailing list
> Tentec at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/tentec
>