[TenTec] OMNI VI&PC control problem

[Charles Greene]

Sergi,

I have no problem on my OMNI-VI.  Check the settings of the serial port 
speed, done by menu on the radio, per the manual, match to the 
program.  Also check the wiring of the DB 25.   Some programs may need 
handshaking signals.  The radio doesn't, but to be sure wire the DB 25 per 
the manual and that will send handshaking signals back to the computer.  I 
have not used either of the programs you have used, but I know MixW 
works.  If the program you are using doesn't have Ten-Tec OMNI-VI as one of 
the rigs, use the ICOM IC735.  Not all Ten-Tec rigs use the same protocol.

At 05:10 AM 12/13/2003, =?koi8-r?Q?=22?=Sergei Kulyov=?koi8-r?Q?=22=20?= wrote:
>Dear OMNI VI users:
>
>need your advise on following. I've got the OMNI VI radio (563 model) with 
>option 3 installed. The logic EPROM label says: Model 564, 98369
>Version 1.02-150 (Logic). The problem is  - I can not communicate via the 
>interface DB25 port. Was trying couple programs: DX4WIN and TRX manager. 
>No luck.
>
>Is there any tips which can be usefull to solve the problem?
>
>Thanks in advance
>
>73, Sergei UA3AP
>
>Moscow
>
>
>
>
>
>_______________________________________________
>Tentec mailing list
>Tentec@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/tentec

73, Chas,  W1CG
K2 462b, 3571