[TenTec] Scout headphone impedence

[Will White]

The headphone output on my Scout is listed in the manual at 600 ohms, and I have
no set of phones even close to that value. The manual suggests padding the
phones plug (not the jack) with resitors to obtain a reasonably close match to
mass market 8/16/32 ohm stereo headphones, but doesn't say how to do this.

Do I use a 300 ohm resistor on each phone lead, or a 600 on one side?  Do I wire
it/them in series, or across (and would that be across the left/right, or one
resitor across *each* pair of wires?)? I are confused!

--
Will White, KD7BFX
Seattle WA US
King County, Grid CN87tq
ITU Zone 6, CQ Zone 3
***************************************************
"The wireless telegraph is not difficult to understand.
The ordinary telegraph is like a very long cat.
You pull the tail in New York, and it meows in Los Angeles.
The wireless is the same, only without the cat."
                                                      - Albert Einstein
***************************************************