[SixClub] Best laid plans...
Richard J. Fiero II A.R.S. W5TFW
joeyw5tfw at gmail.com
Sat Sep 1 01:24:22 EDT 2012
GOOD DEAL !
NASTY WET WINDY HURRICANE here ! no utilities for 48 HRS. BUT we are
OK. havent heard from George & LISA yet !
Joey
A.R.S. W5TFW
Richard Joey Fiero II
----- Original Message -----
From: "K8RI on Six" <50MHz at rogerhalstead.com>
To: <sixclub at mailman.qth.net>
Sent: Friday, August 31, 2012 11:28 PM
Subject: Re: [SixClub] Best laid plans...
> On 8/31/2012 1:42 AM, K8RI on Six wrote:
>> I believe it was about a week ago, I said I hoped to have the BU antenna
>> up the next day...Welll... The new AV640 is finally together and on the
>> saw horses next to the R8 vertical.
>> Seems as I ended up on weight restrictions for a while...Again!
>> At least no more heart attacks or strokes.
>
> Success!
>
> <snip>
>
> This morning I swapped the AV-640 for the R8. I left the dimensions as
> the set up called for. The book also calls for leaving the top hats full
> size rather than cutting them as shown in the manual.
>
> I only had to adjust 40 20 and six.
> I over shot on 40 and under shot on six depending on how you look at it.
> 20 was close enough to use.
>
> Due to the multi band nature, if you get too far off frequency on some
> of the bands like six it gets a bit strange, which is where the VNA is
> really handy in setting up the bands.
>
> I still need to shorten the radiator a couple inches for 40 meters and
> lengthen it about an inch or so on six, but both are currently close
> enough to use without an auxiliary tuner.
>
> I think I may have mentioned that I can let the antenna down, make
> adjustments and crank it back up into position in just over 5 minutes,
> but I do show that winch handle a lot of respect.
>
>
> So...where were all you guys on 6 this afternoon?
>
>
>>
>> Sooo... N8ERF came over and move the AV-640 out to the saw horses which
>> have the R-8 laying on them, still mounted on the 24' mast. I just need
>> to remove the R-8 and install the AV-640 onto the mast. BTW after
>> running all the bands on the R-8 through the VNI I never even put power
>> to it. Unfortunately my wife broke up the shipping boxes and they went
>> to the recycler yesterday.
>
> Actually after I let the R-8 down and disconnected the guy lines "some
> one" ran over both screw in anchors with the lawn mower. I've gotta
> pull the mower deck, but I have a feeling that it was harder on the deck
> and spindle bearings than it was on the anchors. Those anchors are 1/2"
> spring steel rod with a triangular top with the rest coiled up so they
> can be screwed into the ground. They are about 18" over all in length.
> The mower deck straightened out the tops and part of the coiled part
> while pulling them completely out of the ground.
>
> At any rate the AV640 is up and useable. It may be my backup antenna,
> but after a little more tweaking comes the top section for the 25G and
> the tribander. I've pretty much decided to just put up the tribander
> and forgo the WARC 7. I'd rather concentrate on the 3L 4 and 7L 6-meter
> antennas
>
> 73
>
> Roger (K8RI).
>
>>
>> So I'm a good week behind, but making progress.
>>
>> 73
>>
>> Roger (K8RI)
>>
>> ______________________________________________________________
>> SixClub mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/sixclub
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:SixClub at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>
>
> ______________________________________________________________
> SixClub mailing list
> Home: http://mailman.qth.net/mailman/listinfo/sixclub
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:SixClub at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
More information about the SixClub
mailing list