[SignalOne] CX-11A question

[Danny Goodman]

Thanks to all who responded with suggestions. I spent the afternoon
reseating board connectors (top and bottom) and tightening up all PCBs I
could reach, but, alas, no change. It may still be a simple mechanical
issue, but without much here in the way of test equipment, it's tough to
trace where the problem lies.

The whole issue came up because I want to sell the rig, and was going to put
it up on you-know-where. Cosmetically, it's a very fine specimen,
WARC-equipped, and unmodified from the way I received it from Paul Kluwe. It
gave me many hours of operating enjoyment, but it deserves to be restored to
operating condition by someone who knows S/1s.

Here are some photos I took about a year ago:
<http://dannyg.com/ebay/cx11a_1.jpg>
<http://dannyg.com/ebay/cx11a_2.jpg>
<http://dannyg.com/ebay/cx11a_3.jpg>
<http://dannyg.com/ebay/cx11a_4.jpg>
<http://dannyg.com/ebay/cx11a_5.jpg>

And here's a photo I took today:
<http://dannyg.com/ebay/cx11a_6.jpg>

If you're interested in this CX-11A, please email me at a separate address
that will get past my spam filters (disguised here to ward off automated
harvesters):

consult
  followed by the @ sign, followed by
dannyg.com

I'm located in the San Francisco Bay area.

73,
Danny AE9F


>I've had a CX-11A for several years (got it from Paul Kluwe), but left it
>dormant for the last year or so. Upon firing it up recently, I see that the
>display shows xx.900.0, and does not change with either PTO control. The MHz
>part of the display changes with the bandswitch, and I am not getting any
>receive audio. I reseated the display board, and cycled through the PTO push
>buttons many times.
>
>Any suggestions on where to start troubleshooting?