[Scan-DC] Pro-96 comment

Wed, 17 Dec 2003 00:24:08 -0500

 It just goes back to Scan Down mode. If it was in Scan up, it displays ID
Hold Mode and stays put. In scan down I can enable ID Hold if it stops on a
TG and I hit pause.
John

-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Jack Anderson
Sent: Tuesday, December 16, 2003 8:21 AM
To: [email protected]
Subject: RE: [Scan-DC] Pro-96 comment 

Mine holds fine regardless of whether scan up or scan down is active. I
tried it several times in several different configurations, including with
the antenna not attached to simulate not receiving the control channel when
hold mode is first turned on. Do you see "ID Hold Mode" in the display in
both cases, or does it just say "Scan Up" or "Scan Down" after you hit FUNC
TRUNK?