[R-390] R-390 Mechanical Alignment

[thoyer]

Yes, I Jacques and Cecil confirmed my questioning of the alignment text.

Thank you for asking

Tom
W3TA 

-----Original Message-----
From: comcents [mailto:comcents at bellsouth.net] 
Sent: Tuesday, February 23, 2021 4:29 PM
To: thoyer
Cc: R-390 at mailman.qth.net
Subject: Re: [R-390] R-390 Mechanical Alignment

is the original question / issue resolved?

I believe my manual is R390 A/ 391(A) is from 1953 and may have the
answer(s)

I rebuilt my 391 in early to mid 70's from that manual, but I don't claim to
remember much about it now. I had an advantage we do not have anymore (Randy
was handy if I had a question)


Sherry G

On 2/22/2021 7:29 PM, thoyer via R-390 wrote:
> Cecil,
>
> You are correct, it is my typing that is bad - not enough zeros (same 
> could be said for my paycheck!)
>
> Just finished going through the mech alignment at 02 000. Someone was 
> in there before as two of the Bristol head screws were fairly 
> stripped. I was able to get them out and found some replacements in 
> one of my spare parts boxes.
>
> Onward and upward!
>
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net Please help support this email 
> list: http://www.qsl.net/donate.html