[R-390] Right angle mini BNC disassembly

[Glenn Little WB4UIV]

That endplate was probably pressed in place.
If there is solder present, remove as much as possible then use a piece 
of piano wire or similar to push the plate back off.

Glenn


On 5/7/2019 5:03 PM, jgedde at optonline.net wrote:
> I need to replace the coax due to an open in my IF output cable.  On one end
> there's a straight mini-BNC connector which comes apart easily and the
> center contact can be reused.  The right angle one is not so clear to me.
> The wire is easy to take out, but it's not at all clear how to get at the
> center conductor to solder on the new coax.  Any ideas?  It almost looks
> like there's an end plate that's soldered in but it doesn't seem to come
> out.
>
>   
>
> John
>
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

-- 
-----------------------------------------------------------------------
Glenn Little                ARRL Technical Specialist   QCWA  LM 28417
Amateur Callsign:  WB4UIV            wb4uiv at arrl.net    AMSAT LM 2178
QTH:  Goose Creek, SC USA (EM92xx)  USSVI LM   NRA LM   SBE ARRL TAPR
"It is not the class of license that the Amateur holds but the class
of the Amateur that holds the license"