[R-390] Right angle mini BNC disassembly

[Foster]

Greetings,
	At the elbow the round disk is soldered in. Good Luck.(new ones are
available)
Thanks for the pictures too..
73//Foster W4HCX 

-----Original Message-----
From: r-390-bounces at mailman.qth.net [mailto:r-390-bounces at mailman.qth.net]
On Behalf Of jgedde at optonline.net
Sent: Tuesday, May 07, 2019 2:04 PM
To: 'R390 (E-mail)'
Subject: [R-390] Right angle mini BNC disassembly

I need to replace the coax due to an open in my IF output cable.  On one end
there's a straight mini-BNC connector which comes apart easily and the
center contact can be reused.  The right angle one is not so clear to me.
The wire is easy to take out, but it's not at all clear how to get at the
center conductor to solder on the new coax.  Any ideas?  It almost looks
like there's an end plate that's soldered in but it doesn't seem to come
out.

 

John

______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-390 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html