[R-390] Procedure for setting T401

[Larry H]

Hi Dave,  I know that my 390As says T401 on the T207 can, so I assume you
meant T207.  It should be adjusted for maximum 17 mh signal while
monitoring it with a scope on V202 pin 7.  You should only see a nice clean
17 mh signal with it in AGC mode and no input, if there's something else in
there, that's a problem.

Regards, Larry

On Tue, Jul 16, 2019 at 10:46 AM dog <agfa at hughes.net> wrote:

> Since the voltage on E209 is so hot in my 390A (-30VCD), I've been
> looking for a procedure to set T401. I don't seem to be able to find
> anything. Any ideas? I thought maybe I'd stick a high Z probe in E209
> and look at it on the spectrum analyzer and set it for the best 17MHz
> signal. Don't know if there's any harmonics or glitches that are making
> it so high but maybe the SA would tell me something. I haven't looked at
> my other 390A, it's all apart right now, I should start putting it back
> together before I start loosing parts.
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>