[R-390] Pinned Down - advice needed

[Thomas Chirhart]

I'm going to try modifying a couple of small "C" clamps and make up a pin extractor, shouldn't be too difficult...
73
Tom K4NCG
Sent from my iPhone

On Jun 22, 2012, at 2:43 AM, Raymond Cote <bluegrassdakine at hotmail.com> wrote:

> 
> GREAT info Roger.  I will use your idea and keep it handy.
>> To: R-390 at mailman.qth.net
>> From: flowertime01 at wmconnect.com
>> Date: Thu, 21 Jun 2012 18:50:37 -0400
>> Subject: Re: [R-390] Pinned Down - advice needed
>> 
>> 
>> Chris,
>> 
>> You may want to get your self a pair of vise grip pliers.
>> 
>> Set the up in the drill press and drill a very small hole in one jaw.
>> 
>> Into the small hole you would like to insert a short length of the drill
>> bit you used to drill that hole.
>> 
>> You now have a pin in a pair of pliers you could use to work the roll 
>> pin out of the collar and shaft.
>> 
>> You could pull a small bench vise apart and drill a hole in it
>> Some thing to make up a small press.
>> 
>> Roger AI4NI
>> ______________________________________________________________
>> R-390 mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/r-390
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:R-390 at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>                         
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html