[R-390] Pinned Down - advice needed

[Steve Byan]

On Jun 18, 2012, at 11:02 PM, Chris Kepus wrote:

> Where does one buy the extremely small diameter super strong punches? Has
> anyone devised a "best" way to remove the pins? Heating the hub?, soaking
> with penetrant?, drilling 'em out, etc. Yes, I've considered cutting them
> off with a Dremel with cutting wheel but it would be rather difficult to do
> so without collateral damage.

Are they dowel pins or roll pins?

Here's some sources for pin punches for dowel pins:

<http://www.amazon.com/General-Tools-SPC75-Drive-8-Piece/dp/B00004T7RT>

<http://www.amazon.com/Starrett-S565WB-Drive-Punch-Pieces/dp/B00008IHTJ/ref=pd_sbs_indust_2>

<http://www.micromark.com/pin-pusher,10283.html>

<http://www.micromark.com/press-it-precision-arborandpunch-press,9309.html>

<http://www.mcmaster.com/#pin-punches/=i1o76u>


-- 
Steve Byan <stevebyan at me.com>
Littleton, MA 01460