[R-390] need help with390A RF dedk

[rbethman]

Roger - Chine in here!

Oops!  The MC detent will have to be set in the 6 position.

Old minds - they forget things......



rbethman wrote:
> Russ,
>
> You are going to HAVE to drop the front and perform the mechanical 
> alignment of the gear train.
>
> The veeder root counter will need to be set to 7000.0+.  This will be 
> with the KC at its 10 turns fully CW.
>
> Make sure the MC switch detent is set to 7.
>
> Align all gear lobe pointed portions to align with the marks on the 
> front of the slug racks.
>
> It sounds as though someone just threw it together without paying ANY 
> attention to the mechanical positioning.
>
> Have you got the Y2K manual?
>
> Bob - N0DGN
>
> wb3fau at att.net wrote:
>> Some helpful pointers on getting my 390a project  running.  I cannot 
>> hear any signals.  I do see
>> that  it  is out  of mechanical  alignment.  Turning the MC. knob it 
>> will only run up  to 26 mc at that point  it seems to  jam, will  not 
>> turn  any further.  10 turn stop is at zero CCW when display says 
>> 00MC.  Any thoughts?  Russ WB3FAU.       
>> _____________________________________________________________
>> R-390 mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/r-390
>> Help: http://mailman.qth.net/faq.htm
>> Post: mailto:R-390 at mailman.qth.net
>> Unsubscribe: http://mailman.qth.net/mailman/options/r-390
>>
>>   
>
> _____________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/faq.htm
> Post: mailto:R-390 at mailman.qth.net
> Unsubscribe: http://mailman.qth.net/mailman/options/r-390
>