[R-390] 390A Drawings, was Engraved front panels

[Bryce Ringwood]

Stamped ? - Nice job then. Mine looks exactly like the panels I get made
for my instruments - done on a rotary engraving machine. There are
plenty of outfits here who do that. 

OT - I once tried getting a front panel engraved using photosensitive
chemicals.  The result was OK, but not as nice as the rotary engraver.
The letters weren't cut as deep. Somethng you can do at home. - Bryce

PS Don't dry the photoresist in the XYL's oven.

-- 
This message has been scanned for viruses and dangerous content by 
MailScanner, and is believed to be clean.

"The CSIR exercises no editorial control over E-mail messages and/or
attachments thereto/links referred to therein originating in the
organisation and the views in this message/attachments thereto are
therefore not necessarily those of the CSIR and/or its employees.  
The sender of this e-mail is, moreover, in terms of the CSIR's Conditions
of Service, subject to compliance with the CSIR's internal E-mail and 
Internet Policy."