[R-390] Replacement Carrier Level Pot.

[Scott, Barry (Clyde B)]

As I recall, it was pretty much plug-n-play.  The only hitch is fitting the pot in place.  It is "deeper" than the original one.  Again, if memory serves, I took both pots out of the bracket, removed the screw under the other pot (enabling me to pull the bracket up just a tiny bit), put the Claristat in, replaced the screw, and then the other pot.  Wiring was straight forward.

BTW, you're going to like it when you get it in place.  You can "see" the windings as you adjust it, but it stays PUT once you get it where you want it!

Barry(III) - N4BUQ

> 
> I have aquired a replacement Claristat carrier level pot (10 turn) to
> replace my drifting carrier level pot.  Can someone send me the wiring
> directions if you have used a precision pot to replace the stock one ?
> Looks pretty straight forward but ...
> 
> Thanks,
> 
> Mike
> --
> Michael Melland, W9WIS
> Winneconne, Wisconsin USA EN54pc
> qrp-l #1656 - qrparci # 9875 - iparc #252
> ars #1075  -  http://www.qsl.net/w9wis
>