[R-1051] R-1051 plug

[mikea]

On Tue, Dec 20, 2005 at 09:39:18PM +1030, L.D. Ritta wrote:
> 
> Howdy Folks
> 
> I have finally got a R-1051F after over 3 years trying but I need the power
> socket, can someone tell me where I can buy one etc. I'm told it is 3kc off
> frequency any ideas where to start looking? anyone with a manual for the
> R-1051F/URR?

>From earlier posts to the list: 

: The power connector you need is a MS3106A-16-5S
: I don't have the part number for the 2 pin audio, so hopefully
: Cecil will chime in with that.
: 
: I usually buy my cannon connectors from either Allied or a
: local outfit www.randolphandrice.com - might try them as
: well, there is an email link on the page for Mike Deal who
: usually orders my connectors for me. They do mail order
: and are a bit less than Allied. There is also the William Perry
: Company that many folks rave about when buying MS type
: connectors, but I have never bought anything from them.

and 

}         The connectors I purchased were made by Amphenol....they were bought 
} through Allied electronics.
}  
} The Audio connectors are actually 2 pieces...the connector and the strain
} relief that screws onto the back of the connector.
} 
} MFG P/N 97-3106A-10SL-4S  Connector    Allied P/N    714-4004
} MFG P/N 97-3057-1004           Strain relief    Allied P/N    714-2502
} 
} The Power connectors are 3 individual pieces...the connector shell, the
} connector insert and the strain relief.
} 
} MFG P/N 97-3106A-16S     Connector shell      Allied P/N    712-2055
} MFG P/N 97-16S-5S            Connector insert    Allied P/N    712-2237
} MFG P/N 97-3057-1008       Strain relief            Allied P/N    714-2506
} 
} At the time they were not able to provide a part number that included all
} the parts so I had to order each separately.  Things may have
} changed...that's been probably 3 years ago.  These are the same parts used
} by the military...most of the numbers were pulled from a set of connectors I
} had that came with one of my radio's.  The are OD green anodized...of course
} they may all be that way...I'm not sure.
} 
} A warning...they are not cheap either...you should expect a full set of
} connectors (2 audio 1 power) will cost you around $60 shipped....that was
} based on prices 3 years ago...I haven't checked the prices lately..I would
} expect they have gone up...

and 

= Think I found a source for new connectors if you ever need any
= http://www.cdc-online.com.
= Connector numbers are:  MS-3106E105L-4S for audio,
= MS-3106R165-5S.  Both are ITT-Cannon.

and 

@ Checked Allied and you're pretty much dead on Cecil, total for a complete
@ set (two audio - one power), with shipping, will be about $60.00
@ 
@ Audio:
@ MFG#  97-3106A-10SL-4S   Connector          Allied#   714-4004   $12.39  In Stock
@ MFG#  97-3057-1004       Strain Relief      Allied#   714-2502    $4.88  In Stock   
@ Power:
@ MFG#  97-3106A-16S       Connector Shell    Allied#   712-2055    $7.11  In Stock
@ MFG#  97-16S-5S          Connector Insert   Allied#   712-2237    $4.12  In Stock
@ MFG#  97-3057-1008       Strain Relief      Allied#   714-2506    $4.47  In Stock

I don't have a manual for my H-model, either. Maybe Cecil can help. 

Hope this helps. 

-- 
Mike Andrews, W5EGO
mikea at mikea.ath.cx
Tired old sysadmin