[R-1051] LSB/USB problem

[Steve Hobensack]

Joe, 
The problem might be in the mechanical linkage behind
the far right knob. It goes to the 1 & 10 kc
synthesizer (all in the same module). The chain drive 
may have slipped or the coupler plate might have
rotated on the shaft. Be sure the coupler plates mate
properly. You should be able to turn the coupler plate
on the module with your fingers for alignment before
installing the six pack. You may have to slip the
chain sprocket behind the number window and hold the
chain stationary while turning the knob to the correct
number. Armchair trouble-shooting is easier than the
real thing. Those rigs can be real buggers.
..73 ...Steve..KJ8L


--- bepi <bepip at adriacom.it> wrote:
> Hallo for Italy,
> 
> a question to  list,
> 
> I got a nice 1051/URR that works fine, but has this
> problem:
> in all bands any LSB or USB signal is 1 Khz down for
> correct demodulation, 5 Mhz master osc. is ok.
> 
> Any idea ? thanks in advance and 73 de Joe, IV3PVD
> (north - east parth of Italy)
> 
> > _______________________________________________
> R-1051 mailing list
> R-1051 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/r-1051
> 



	
		
__________________________________
Do you Yahoo!?
SBC Yahoo! - Internet access at a great low price.
http://promo.yahoo.com/sbc/