[R-1051] kilocycle knob stops

[Steve Hobensack]

Thanks for the info Cecil.  I'll get right on the
project. I should have asked this question a year ago
and save some sore fingers.

cul
Steve,  KJ8L

--- Cecil Acuff <chacuff at cableone.net> wrote:
> Hi Steve,
> 
>         Just got back in town and saw your
> note...don't know if anyone
> responded but it's a simple thing to do!  You remove
> the knobs, remove the
> nut on the shaft, remove the funny shaped washer
> behind the nut and
> preferably replace it with a small diameter flat
> washer to protect the panel
> and replace nuts and the three knobs!
> 
> Your done!  Wish they were all that easy.  I didn't
> even think of it until I
> had a "D" model in the shop and noticed that that's
> the way they were
> shipped.  Don't know why they were ever there to
> start with!
> 
> Enjoy!
> 
> Cecil....
> ----- Original Message -----
> From: Steve Hobensack <stevehobensack at yahoo.com>
> To: <r-1051 at mailman.qth.net>
> Sent: Sunday, October 06, 2002 9:09 AM
> Subject: [R-1051] kilocycle knob stops
> 
> 
> > Has anyone modified the r-1051b kilocycle change
> knobs
> > so they won't stop between zero and nine? Is it
> > possible without a lot of hassle? Thanks
> >
> > __________________________________________________
> > Do you Yahoo!?
> > Faith Hill - Exclusive Performances, Videos & More
> > http://faith.yahoo.com
> > _______________________________________________
> > R-1051 mailing list
> > R-1051 at mailman.qth.net
> > http://mailman.qth.net/mailman/listinfo/r-1051
> 
> _______________________________________________
> R-1051 mailing list
> R-1051 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/r-1051


__________________________________________________
Do you Yahoo!?
Faith Hill - Exclusive Performances, Videos & More
http://faith.yahoo.com