[QRP] DC40 board

[CPARRISH104 at cfl.rr.com]

Mike,

Thank you very much for your informative message. I believe that will
fit in an LMB enclosure that I already have.

Thanks again, Curt

----- Original Message -----
From: "M.J.Friel (Cableone)" <frielmj11 at cableone.net>
Date: Tuesday, April 18, 2006 2:29 pm
Subject: Re: [QRP] DC40 board
To: Low Power Amateur Radio <qrp at mailman.qth.net>

> Curt,
> The PC board measures 2.07" x 3.27". Allowing for the key & phone jack
> bodies it is 3.85". Including the threaded part of the jacks is 
> 3.425". The
> height would be about 0.7" depending on the length of the underside 
> solderjoints. The crystal is the tallest component. If you put the 
> crystal in sip
> sockets, then it is taller, of course. These measurements are using 
> a dial
> caliper. This does not allow for clearance. Stock, as per the 
> instructions,it will fit in the altoid tin with necessary 
> clearance, but the antenna and
> power connections should be on leads to the outside; there isn't 
> much room
> for jacks. It's a very nice little kit which offers some ideas for 
> upgradeand variation. See all the pdf data on Doug Hendricks' web 
> site.Mike  KB7WYI
> 
> ----- Original Message ----- 
> From: <CPARRISH104 at cfl.rr.com>
> To: <qrp at mailman.qth.net>
> Sent: Tuesday, April 18, 2006 6:55 AM
> Subject: [QRP] DC40 board
> 
> 
> > Hi,
> >
> > Could anyone tell me the dimensions of the DC40 pc board sold by
> > Hendricks Kits?
> >
> > Thanks, Curt, K4TL
> > _______________________________________________
> > QRP mailing list
> > QRP at mailman.qth.net
> > http://mailman.qth.net/mailman/listinfo/qrp
> 
> _______________________________________________
> QRP mailing list
> QRP at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/qrp
>