[QRP] DC40 board

[M.J.Friel (Cableone)]

Curt,
The PC board measures 2.07" x 3.27". Allowing for the key & phone jack
bodies it is 3.85". Including the threaded part of the jacks is 3.425". The
height would be about 0.7" depending on the length of the underside solder
joints. The crystal is the tallest component. If you put the crystal in sip
sockets, then it is taller, of course. These measurements are using a dial
caliper. This does not allow for clearance. Stock, as per the instructions,
it will fit in the altoid tin with necessary clearance, but the antenna and
power connections should be on leads to the outside; there isn't much room
for jacks. It's a very nice little kit which offers some ideas for upgrade
and variation. See all the pdf data on Doug Hendricks' web site.
Mike  KB7WYI

----- Original Message ----- 
From: <CPARRISH104 at cfl.rr.com>
To: <qrp at mailman.qth.net>
Sent: Tuesday, April 18, 2006 6:55 AM
Subject: [QRP] DC40 board


> Hi,
>
> Could anyone tell me the dimensions of the DC40 pc board sold by
> Hendricks Kits?
>
> Thanks, Curt, K4TL
> _______________________________________________
> QRP mailing list
> QRP at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/qrp