[Premium-Rx] Watkins Johnson VXI Receivers and RCS32

[Trevor Barron]

Hi Spencer,
I looked at the 8721, 8634, and 8629 VXI receivers and none of those support a serial interface for control.  Those receivers are operated under VXI bus control only.  Is there a particular VXI receiver you had in mind?  The configuration of RCS32 software is set to match the serial speed or type of interface of each of the attached devices. It doesn't configure the interfaces on the attached devices.

Trevor

-----Original Message-----
From: spencer bahner via Premium-Rx <premium-rx at mailman.qth.net>
To: premium-rx at mailman.qth.net <premium-rx at mailman.qth.net>
Sent: Sat, Apr 24, 2021 3:48 pm
Subject: [Premium-Rx] Watkins Johnson VXI Receivers and RCS32

Do any of you Premium RX WJ fans know how you set the front panel RS232 port speed on the WJ VXI package receivers that allow for serial control? This applies to the later generation receivers that have no switches to configure the serial ports. I have read through the RCS32 manual and can’t locate any reference to how this is done. Perhaps it’s a factory set function only? Thanks for any guidance anyone can offer.

-Spencer K7SLB
______________________________________________________________
Premium-Rx mailing list
Home: http://mailman.qth.net/mailman/listinfo/premium-rx
Help Page: http://mailman.qth.net/mmfaq.htm
Post: mailto:Premium-Rx at mailman.qth.net
Help Contact eMail:  radio at 8zo.com
Home Page:  http://www.premium-rx.org/