[Premium-Rx] RF-590 A12 Assy Schematic

[Mac]

Tom i think my response to this has pretty well been resolved, but i 
never answered yes J5 is shown as the 800 hz port, while 6 and 10 
were/are the 1 mhz same identical port points.  mac/mc  w5mc

On 7/20/2019 8:07 PM, thoyer via Premium-Rx wrote:
> Troubleshooting an RF-590 and have an issue with the 800kHz ref output on
> the A12 board. The component placement drawing I have found on the web does
> not match my board. My A12 board has the following part numbers on it:
> 10073-4700
>           -4709E
>   
> The component placement drawing I have is 10073-4700 Rev E. It shows J5, J6
> and J10 in the upper left corner of the drawing but my board only has J5 and
> J6, Plus CR9 is shown opposite of how it is populated on the pcb.
>   
> Can someone point me in the right direction please?
>   
> Thank you,
>   
> Tom
> W3TA
> ______________________________________________________________
> Premium-Rx mailing list
> Home: http://mailman.qth.net/mailman/listinfo/premium-rx
> Help Page: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Premium-Rx at mailman.qth.net
> Help Contact eMail:  radio at 8zo.com
> Home Page:  http://www.premium-rx.org/
>