[Premium-Rx] Line voltage for a ITT Mackay 3020

[ToddRoberts2001 at aol.com]

In a message dated 12/12/2004 4:03:40 PM Eastern Standard Time, 
mparkinson1 at socal.rr.com writes:
I made a request for the wrong model for changing the Line Voltage on a     
3041 what I need is the line change information on a ITT Mackay 3020 receiver 
I cannot find where the change can take place I don't have a manual for it.
Also the receiver is labled Debeg but the back of the receiver says ITT 
Mackay.
I need to change it from 220 to 115 operation.
Anyone out there have any information on how to change this.
thanks Matt
                                             To change the receiver to 115 
volt operation, the transformer primary windings must be connected in parallel.  
Terminals 1 and 3 must be strapped and terminals 2 and 4 must be strapped. 
The 115 volts is applied to terminals 1 and 4. For 230 volts you will see that 
only terminals 2 and 3 are strapped. Transformer strapping is located on the 
underside of the receiver chassis and access is gained by removal of the 
underside rear cover plate. Hope this info helps. 73 Todd WD4NGG.