[Premium-Rx] Collins 95S-1 DSP Receiver

[w3jn]

I don't have a schematic or manual but that radio should have an internal 
power supply as well as an internal speaker.  Unless you're determined to 
runit off DC I wonder why you need this info.

The serial port is a standard RS-232.  You will need the manual or the 
Collins software to run it, as there are a bazillion commands (that must be 
sent in the proper syntax) to set the various functions.

Believe the DIP switch is to set the RS-232 speed, # of bits, etc.  IIRC it 
defaults to 9600.  A few minutes with windows terminal program should figure 
it out.

Get the radio powered up first, then the rest should follow fairly easily.

This is an outstanding radio in every respect, and I'm sure you'll be 
impressed when you get it working.

Good luck and 73, John

----- Original Message ----- 
From: "Scott Schappert" <scottsch at ix.netcom.com>
To: <premium-rx at ml.skirrow.org>
Sent: Sunday, December 05, 2004 4:44 PM
Subject: [Premium-Rx] Collins 95S-1 DSP Receiver


> Hello and pleasant Sunday to the list !
>
> I have a Collins 95S-1 DSP (single board) receiver that I am in the 
> process
> of setting up, but have only descriptive documentation on.  Specifically, 
> I
> am looking for a schematic, or detailed block diagram that will allow me 
> to
> verify and correctly wire power and ground (IO 10 pin header)  Audio, etc.
> (IO 16 pin header) P800, serial comm P701, also jumper settings on P704.
>
> A schematic would be very nice, but less granular information on the basic
> IO and settings on the PCBA is really needed.  If anyone has any 
> information
> or experience on this receiver, I would be extremely grateful to hear from
> you.
>
> Thanks in advance for your consideration !
>
> Best regards to all !
>
> -Scott
>
>
>
> _______________________________________________
>
> Premium-Rx Mailing List
> To Post: premium-rx at ml.skirrow.org
> For Info: http://ml.islandnet.com/mailman/listinfo/premium-rx
> Visit the Website: http://kahuna.sdsu.edu/~mechtron/PremRxPage/