[Premium-Rx] Harrids RF590 Tuning steps

[Richard Reich]

Hi List.

I have a Harris RF590 which has a feature I'd like to change (because it drives
me mad with irritation).

When the radio is powered-up, the default manual tuning step is always 1MHz.
However, it 'remembers' every other setting last used (eg; mode, IF BW,
frequency, etc). 

Is there any way to change this default (I assume it isn't firmware) so that
when switch on it defaults to, say, 100Hz? - or even just remembers the last
tuning step that was last used?

My manual is limited in this respect. Any help would be highly appreciated.

Its interesting to see how a superb design can be completely ruined by 'clumsy'
ergonomics.

Many thanks.

Richard
***************************************************************
Richard Reich    
Principal Engineer Hardware
SAAT Technology Ltd
Web: http://www.saatt.co.uk

DDI: +44(0)1420 545388
Fax: +44(0)1420 87259

Privileged, confidential and/or copyright information may be contained
in this e-mail. This e-mail is for the use only of the intended addressee.
If you are not the intended addressee, or the person responsible for
delivering it to the intended addressee, you may not copy, forward,
disclose or otherwise use it or any part of it in any way whatsoever.
To do so is prohibited and may be unlawful.

If you receive this e-mail by mistake please advise the sender
immediately by using the reply facility in your e-mail software.

This message is subject to and does not create or vary any contractual
relationship between SAAT Technology Limited and you.

Registered Office: Test House, Mill Lane, Alton, Hampshire, GU34 2QG
Registered in London. No. 4106589