[PCR-1000] TalkPCR audio switch

Thu, 9 Jan 2003 13:22:28 -0500

That's a good point about that switch, located inside the PCR-1000.  It
controls whether the audio is outputted to the built in speaker in the
PCR-1000 case, or if it sent to the external output jack.  I would check =
to
make sure that the switch is set one way or the other.  It may be =
possible
that the switch may have been bumped into the center, and neither audio =
out
to the speaker or the jack is working.  Try working the switch back and
forth a couple of times and then leave it in one or the other position.

Marty

-----Original Message-----
From: [email protected] =
[mailto:[email protected]]
On Behalf Of Skip Flem
Sent: Thursday, January 09, 2003 10:06 AM
To: [email protected]
Subject: RE: [PCR-1000] TalkPCR=20

> Also, make sure that the output has not been muted.  In TalkPCR, you
can=20
>  double-click on the volume control "knob" to mute and unmute.

> Or that the squelch is too tight...
 And when you find out everything is working with the speaker and you
want to use the audio through your PC, there's a little switch
(mentioned on page 3 of the manual) that puts the PCR-1000 in the Line
Out mode. To match the
Line In on your soundcard.
 Skip Flem, NT1G PCR-1000/NIR-12

_________________________________________________________________
PCR-1000 Mailing List
Post Address: [email protected]
Subscribe / Unsubscribe:=20
http://mailman.qth.net/mailman/listinfo/pcr-1000
Mailman FAQ and Users Guide
http://mailman.qth.net/faq.htm