[PCR-1000] PCR 1000 Bandscope Spurious Signal

Robert DeShazer [email protected]
Sun, 09 Jun 2002 14:02:42 -0500


I have also seen this spurious signal in several pieces of software for the
pcr-1000. The problem appears to originate in one of the IF stages, and this
appears to be the way that the band scope represents the interference.
Always 150 KHZ higher than the Received frequency, and is present even on
quiet bands.

My 2 cents worth

Regards,
Robert DeShazer
----- Original Message -----
From: "Harry Flaxman" <[email protected]>
To: <[email protected]>
Sent: Sunday, June 09, 2002 12:37 PM
Subject: Re: [PCR-1000] PCR 1000 Bandscope Spurious Signal


> I also see the 'spur' with both Scancat Gold and the original Icom
software.
>  There is always a broadcast to one side or the other of it.  I am just
> assuming it's a frequency being used that I can't seem to tune in for some
> reason.
>
> I have never loaded the average values in my radio....being as I saved the
> eprom from the beginning.
>
> Harry
>
>
> On  9-Jun-2002, John wrote:
>
> > Hi All,
> >
> > I too have seen the same problem both with the original Icom software
and
> > also with the far superior TalkPCR.
> > The spurious signal is 150 kHz HI always - but only 2 to 3 Db above the
> > noise floor - and does not cause me any problems. It could be a 'batch'
> > related artifact - the Serial No. of my PCR is 4347. The only (slightly)
> > annoying problem for me is the number of internally generated spurii.
Have
> > you tried running the Spectrum Analyser of TalkPCR with the antenna
> > connector
> > terminated with a 50 ohm dummy load?
> >
> > I first saw it just after firing up the receiver for the first time - I
> > had not backed up the EPROM then..... However, I've tried loading the
> > EPROM
> > with the 'Average Value' set - no change to the spurious noted..
> >
> > Incidentally - has anyone noted any crystal ageing? I set my unit up
very
> > carefully some 2 years ago. I noticed recently that some stations are
> > about
> > 800 to 1000 Hz low - I need to recalibrate!!
> >
> > All the best,
> >
> > John G3PNJ/DJ0MBK
>
> _______________________________________________
> PCR-1000 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/pcr-1000