[NvHam] FS Update

[Jack/W6NF]

Both '757's, the power supply and the W9GR DSP are gone! All other items 
remain.

Jack, W6NF


 > Updating and correcting my recent FS posting:
 >
 > 1) Yaesu FT-757GXII SOLD

 > 2) Yaesu FT-757GX SOLD

 > 3) Pyramid PS-26KS SOLD

 > 4) Radio Shack 21-533 SWR/field strength meter. Says it will handle a
 > kw, but I don't know about that. Looks new with f/s antenna, manual and
 > PL-259 jumper coax. $5.00.
 >
 > 5) Homebrew audio DSP SOLD

 > 6) B&W model 376 "Protax" coax switch with large knob, faceplate and
 > wall bracket. Someone took the rear cover off the switch (perhaps for
 > repair?) but the switch works fine. $10.00.
 >
 > 7) Original SSB crystal filter for Kenwood TS-520. This is a TRIO
 > YG-3395S and was replaced by an INRAD 2.1kHz filter. Works fine. $15.00.
 >
 > 8) Two new GI-7B Russian triodes with considerable documentation on
 > building a kilowatt amplifier using these tubes. $40.00 for both.
 >
 > 9) 6-foot open frame rack with base for floor mounting. Older RCA rack
 > from a broadcast transmitter site. $10.00.
 >
 > 10) Used but serviceable bottom mast support for Ham-M style CDE rotors.
 > Bought on eBay and I subsequently found a tower which makes the support
 > unnecessary. Bracket only, no u-bolts, $10.00.
 >
 > 11) Powerstat variable transformer. 120/240VAC input 0-30VAC output at
 > 25 amps (also labeled 15-0-15VAC at 30 amps). Large and heavy, came out
 > of a broadcast transmitter. $20.00.
 >
 > 12) Precision metering resistor, cartridge style. 1.5kv full-scale with
 > a 1ma meter. Resistor is about 6-inches long and 1-inch diameter. Comes
 > with mounting clips, $5.00.
 >
 > 13) Two Maxon HT's, one CS-0510 VHF HT and one CP-0520-HD UHF HT. The
 > VHF unit is complete, with battery and was functioning last time I
 > tried. The UHF unit is apart, has no battery and is in unknown
 > condition. Comes with  two CA-1110A drop-in chargers. Neither are
 > converted to Amateur Radio frequencies. $10.00 for both.
 >
 > 14) Heathkit HD-1481 remote coax switch. This is the switch only. I
 > built a small power supply (I used a very large transformer which I am
 > keeping) to run the switch and it works fine. Comes with original
 > manual. $20.00.
 >
 > Thanks,
 >
 > Jack, W6NF
 > Silver Springs
 > 1-775-577-4621 (home)
 > 1-775-997-8129 (cell)