[NJARC] Philco 60 Antenna Coil - Open

[Chuck]

Oh okay – glad you got it fixed.
Chuck

From: TrainBee 
Sent: Thursday, March 23, 2017 10:48 AM
To: cpaci1 at verizon.net ; stateasylum at yahoo.com ; njarc at mailman.qth.net 
Subject: Re: [NJARC] Philco 60 Antenna Coil - Open

Thanks Chuck,

I did get it fixed last night. I'm working on some pictures. That was a good video. My coil is slightly different, but has the same function.

Please stand by as I get to the rest of the story.

Regards,

Joe




-----Original Message-----
From: Chuck <cpaci1 at verizon.net>
To: Pete O <stateasylum at yahoo.com>; TrainBee <trainbee at aol.com>; njarc <njarc at mailman.qth.net>
Sent: Thu, Mar 23, 2017 9:41 am
Subject: Re: [NJARC] Philco 60 Antenna Coil - Open

Just remember
Reply = Poster
Reply All = Everyone

_________________________________________________________

Hi Joe,
I found a video that may help you.
See below,
Chuck

Philco 60 restoration p10o14
Time to repair that open SW antenna coil.
https://www.youtube.com/watch?v=RRYr8pY_ViY


From: Pete O via NJARC 
Sent: Wednesday, March 22, 2017 7:40 PM
To: TrainBee ; njarc at mailman.qth.net 
Subject: Re: [NJARC] Philco 60 Antenna Coil - Open

Just remember
Reply = Poster
Reply All = Everyone

_________________________________________________________


--------------------------------------------------------------------------------

It's been my experience that the break in those Philco coils is where the outer winding makes a 90 degree bend and then down to the solder lug.  If it is this outer winding, carefully lift it up out of the wax until you get to the bend. It's part of the coil winding process that puts strain on the bend. Removing that one turn won't hurt anything. A stereo microscope really helps along with some dental tools.


If you are really desperate, you can send the coil to me and I'll check it out under the microscope. No guarantees though.


Pete Olin




--------------------------------------------------------------------------------
From: TrainBee via NJARC <njarc at mailman.qth.net>
To: njarc at mailman.qth.net 
Sent: Wednesday, March 22, 2017 5:28 PM
Subject: [NJARC] Philco 60 Antenna Coil - Open


Does anyone have any experience with rewinding an Antenna Coil (IF) for a Philco 60?  How about another Philco of similar vintage? I have one that has an open winding between terminals 2 and 3.  If not, have you ever rewound a coil and could give some advise?  I'm pretty sure I have the problem narrowed down.  There is no signal generated by the LO and no voltage readings from either terminal 2 or 3.  The ohms readings between the top lug and # 4 isn't close, but at least there is something.  I'm also getting a reading between terminals 1 and 6. Once again, it's not close to the schematic. 

I'd prefer to not rewind the entire coil.  But, if in your experience, this is what's needed, then I'll give it a try.  I've seen the info on Ron Ramirez's site and I'm hoping I can get some more shared experience from our members.  The Philco 60 I am working on is from the Sept. 1934 production run.  It incorporated quite a few of the improvements that Philco had for this radio.  

Thanks in advance for your help.

Joe Devonshire



Just remember
Reply = Poster
Reply All = Everyone

_________________________________________________________
______________________________________________________________
NJARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/njarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:NJARC at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html



--------------------------------------------------------------------------------
______________________________________________________________
NJARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/njarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:NJARC at mailman.qth.net?

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
NJARC mailing list
Home: http://mailman.qth.net/mailman/listinfo/njarc
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:NJARC at mailman.qth.net?

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/mailman/private/njarc/attachments/20170323/aa409d30/attachment.html>