[NJARC] Emerson wireing diagram.

[Aaron Hunter]

Victor

There is probably a good reason why the wires are pulled loose from the 
filter cap.  It is or will be bad.  You're probably better off cutting 
or unhooking all the wires from the filter and wire in three 
electrolytics under the chassis.  Seems the most common value is 10mfd 
at 450 or 500 VDC.  Use three of them and following the Rider schematic, 
the + side is up and the neg. side at the bottom of the schematic.

Any other comments or suggestions?

Aaron

victor bellini wrote:
> Just remember 
> Reply = Poster
> Reply All = Everyone
>
> _________________________________________________________
> I have been trying to restore a 1934 Emerson model 45 BD6 and have reached 
> an impasse. Seems that some wires were pulled loose underneath the chassis 
> leading from the large filter cap. The filter cap is the metal type that 
> sits atop the chassis but has no markings whatsoever either on top or on the 
> underneath. This unit has a power transformer which tests good and I have 
> recapped everything. I have searched high and low and can only find a 
> schematic and the alignment procedures. I just can't figure out from the 
> schematic where the wires in question go. Does anyone know someone who might 
> be familiar with this model or that might have additional Emerson operating 
> manual, wire diagram parts diagram etc.
>
> thanks
> victor 
>
> ______________________________________________________________
> NJARC mailing list
> Home: http://mailman.qth.net/mailman/listinfo/njarc
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:NJARC at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>
>