[NJARC] Cleaning a Chassis

[antqradio at juno.com]

Hi Nick
I use the dishwasher with the normal powdered detergent, rinse cycle
twice, then wrap it in a towel and then pop it into the oven at about 180
degrees for an hour or two.  I just did this with a very dirty 1950 Ford
(Zenith) car radio.  Came out fine.  I might add that Ruth is very
understanding!
Regards,
Jim

On Tue, 15 Feb 2005 19:56:28 -0500 (GMT-05:00) Nick Senker
<ns539 at earthlink.net> writes:
> Next meeting 3/11/05
> NJARC Spring Meet Hazlet, NJ 3/13/05 - See http://www.njarc.org
> _______________________________________________
> I have a very dirty chassis with a sticky film all over the 
> underside.  I thought I would mist with denatured alcohol and use a 
> paint brush to clean accessible parts, then drip dry.  Finally I 
> would use a hair dryer on low heat to dry(using adequate 
> ventillation, eg outside or in a garage with the door open)  Anyone 
> have a better idea?  Nick Senker
> _______________________________________________
> NJARC mailing list
> NJARC at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/njarc
> 
>